Re: Parts Source

[bestalli@eastnet.educ.ecu.edu (Patricia Stallings)]

Thanks, Permatex(Loctite) also makes a tool handle dip.

I found a co call Stock Caps.  They make cap plugs and all sorts of
protective covers for pipe, thread protectors and handle grips.  I will be
requesting some "samples" to evaluate.  They come in colors also.

With my handles installed on the car, the liquid stuff is "no go".


At 17:53 10/6/98 -0400, you wrote:
>Tom,
>        Are you familiar with the (latex?) that is sold in electrical supply
>stores?  It comes in quart and gallon cans.  You can dip pliers and cutter
>handles in it and leave them to dry.  If a thicker handle is desired, dip them
>again.  I forget the name of the stuff.  Hope this helps.
>                                                    Ed Thornton
>                                                    Yorklyn, DE
>
>
>Patricia Stallings wrote:
>
>> Please let me stand under the soap box to ask my simple question.
>>
>> I need some handle bar covers like Fairmont uses on A-car brake levers.
>> These are rubber or plastic and slip on over the flat metal.
>>
>> Sizes I need (this is the metal flat bar size):
>>
>> 1/8 x 1
>> 1/4 X 1 1/4
>> 1/4 x 1 1/2
>>
>> I have seen these in a catalog, but can't remember where.  I have looked in
>> McMaster Carr, Travers, MSC, and Grainger.
>>
>> Any help is appreciated.
>>
>> Now back to brake lights, strobes, newbees, and rear mounted gas cans.  I
>> say yes to three out of four.
>> Tom Stallings, Pinetops, NC
>> 252/827.4693
>
>
>
>
Tom Stallings, Pinetops, NC  
252/827.4693